Hardware Expansion; Multimedia Pocket - Panasonic CF-25 Series Operating Instructions Manual

Hardware Expansion

Multimedia Pocket (MP)
Removal
Mounting
18
The multimedia pocket houses the floppy disk drive (FDD) that comes with this
computer. The FDD can be replaced with an optional unit.
Optional units : CD-ROM Pack (CF-VCD252)
NOTE
Do not replace a unit in the multimedia pocket with another when the computer is in the sus-
pend or hibernation mode. Doing so could damage the unit or prevent the new unit from being
recognized properly.
CAUTION
Make sure that the position of the peripheral connector is located as shown in the illustration
below.
Gently install / remove any multimedia pocket device. Do not use excessive force when in-
stalling.
connector
CAUTION
You may use the floppy disk drive as an external unit that is connected through the parallel port,
by using an optional FDD cable (CF-VCF351). Some precautions are necessary, as described
below, since problems may arise.
Do not move the drive while accessing data on the floppy.
Firmly hold both sides of the drive when removing a disk. If pressure is applied from the top,
excessive force should be avoided.
When you need to format 2HD type floppy disk at the MS-DOS prompt, please type the
command as noted below. Without this option, the disk will not be formatted correctly.
FORMAT
Second Battery Pack (CF-VZS252)
Turn the computer off by pressing
computer switch in the ON position simultaneously.
Turn the unit over.
Open the cover.
Slide the MP release toward the MP device.
The MP device should slide out.
Pull out the device.
Insert an MP unit into the slot.
Push the unit in until it snaps into place.
Confirm that the MP release has returned to its original
position.
A: /F:1.44
and holding the