Hardware Diagnostics - Panasonic CF-Y7 series Operating Instructions Manual

Hardware Diagnostics

If the hardware installed in this computer is not operating properly, you can use the PC-Diagnostic Utility to determine
whether or not there is a problem.
If the utility discovers a problem in the hardware, contact your technical support office.
Hardware that can be checked using the PC-Diagnostic Utility
Hardware below can be checked using this utility. (Software cannot be checked.)
CPU
Memory
Hard Disk
CD/DVD Drive
Video Controller
*1
Sound
Modem
LAN
*2
Wireless LAN
*3
Wireless WAN
*4
Bluetooth
USB
PC Card Controller
SD Card Controller
Keyboard
Touch Pad
*1
When the PC-Diagnostic Utility is running, a loud beep will sound, so do not use headphones at this time. (The beep will not
sound if mute is using Windows.)
*2
Only for model with wireless LAN
*3
Only for model with wireless WAN
*4
Only for model with Bluetooth
When the video diagnostic check is running, the display may be distorted, and when the audio diagnostic check is
running, sounds may be generated from the speakers. These are not malfunctions.
Regarding the PC-Diagnostic Utility
NOTE
For the hard disk only, you can select standard diagnostic check or extended diagnostic check.
When the PC-Diagnostic Utility starts up, it will run the standard diagnostic check.
We recommend that you use the touch pad for operations. When not using the touch pad, you can operate using the
internal keyboard instead. Note, however, that the touch pad and internal keyboard may not function temporarily dur-
ing diagnostic check. If this happens, wait for a moment before operating them.
Operations
Select icon
Click the icon
Complete the PC- Diagnos-
tic Utility and then restart
the computer
If the touch pad does not operate properly, press Ctrl + Alt + Del to restart the computer, or slide the power switch
to turn the power off, and then restart the PC-Diagnostic Utility.
Running the Diagnostic Check
Run this utility using the default settings in the Setup Utility.
If the Setup Utility or other settings will not allow a hardware to be executed, the hardware icon will be displayed in gray.
1 Connect the AC adaptor, and turn on the wireless switch.
During the diagnostic check, do not remove the AC adaptor, or attach any peripheral devices.
2 Turn on or restart the computer, and press
The Setup Utility starts up.
If the password is requested, enter the Supervisor Password.
If you are using the computer after changing the settings from the status at the time of purchase, we recom-
mend that you make a note of the settings that are changed.
32
Touch pad operations
Place the cursor above the icon
Tap or click (right click cannot be used)
Click (close)
Internal keyboard operations
Press Space and then press
( (close) cannot be selected)
Press Space above the icon
Press Ctrl + Alt + Del
while [Panasonic] boot screen is displayed.
F2
