Cleaning The Drain Filter - Daewoo DWM-8010 Service Manual

GEAR HOUSING ASS'Y
The GRAR HOUSING ASSEMBLY is a transmission device which turns the Agitator at 4.18:1 lowered speed
through the gear unit assembly which receives power at the GEAR SHAFT UNIT.
1) The two sides of the GEAR SHAFT UNIT are supported by the
OILLESS BEARING in the GEAR HOUSING ASSEMBLY.
2) The GEAR UNIT ASSEMBLY is connected to the GEAR
SHAFT 1 and GEAR SHAFT UNIT by the GEAR and GEAR
UNIT respectively.
3) The two sides of GEAR SHAFT 1 are supported by the OIL
SEAL and OILLESS BEARING in the GEAR HOUSING
ASSEMBLY.
SPIN BELLOWS ASS'Y
The wrinkled rubber device on the botton of the BASKET SPIN is
called SPIN BELLOWS ASSEMBLY.
It has a waterseal and a oilless metal inside to prevent leakage
and so that the BASKET SPIN may work smoothly.
F i l te r
CLEANING THE OVERFLOW FILTER
1) Pull the overflow filter out from the wash tub by tugging.
2) Wash off, remove lint from the filter and also clean around the
overflow hose.
3) Reassemble by matching the two protrusions at the bottom of
the filter to the slits in the wash tub and then fix the filter into
position.

CLEANING THE DRAIN FILTER

1) To remove the agitator, remove the lint filter assembly.
2) Remove the screw from agitat and pull the agitator upward.
3) Using screw driver undo the securing screws.
4) Rinse the water and reinstal the lint filter.
STRUCTURE
SHAFT AGITATOR
OILLESS METAL
OILLESS METAL
GEAR
INNER GEAR
OILLESS METAL
SHAFT PULLEY
SPIN DRYER
SPIN DRYER SHAFT
WATER SEAL
OILLESS METAL
BELLOWS PACKING
CRUM COUPLING
BELLOWS
SPIN TUB
PROCEDURE 8