Daewoo DWM-8010 Service Manual page 14

PROBLEM CHECK POINT
Is the Bellow Assembly properly
assembled?
There is leak-
age during
spin drying.
The Brake Band touches the
Drum Coupling when the Door
Spin *O open.
Spin Dryer
does not
stop with the
Door Spin
*O open
Is the electric connection of the
Door Switch good?
C o n c e rning Drainga (Pump )
PROBLEM PROBLEM CHECK POINT CHECK POINT
Is the height of the drainage area where
the Drain Hose hangs over 1m?
Are there impurities in the Drain
Strainer?
Drainage is
not satisfac-
tory
Are there impurities in the Valve
Housing or Inlet Joint?
NO
YES
NO
YES
NO
YES
YES
NO
YES
NO
YES
NO
CAUSE
The Waterseal or the oil-
less metal in the Bellows
Assembly worn out.
Waterproofing not working
due to defective assembly.
The Waterseal or the
Oiless Metal in the Bellows
Assembly is worn out.
Brake wire is too short.
Brake Band is worn out.
Defective
Door Switch
The contact of the Door
Switch does not open due
to deformity of the lever of
Door Switch.
CAUSE CAUSE
The Drain Hose is too high.
Impurities are obstructing
drainage.
Impurities are obstructing
drainage.
Impurities are blocking the
Drain Hose
SOLUTION
Replace Bellows Assembly.
Re-assemble
Bellows Assembly.
Replace Bellows
Assembly.
Replace after loosening
Wire Guide and adjusting
upward.
Replace Brake Band or
Brake Fix Assembly.
Replace
Door Switch
Replace Door Switch or
reshape the lever of Door
Switch.
SOLUTION SOLUTION
Hang the Drain Hose lower.
Disassemble Agitaor and
take out impurities in drain
Strainer
Remove impurities or
replace Valve Housing or
Inlet Joint.
Remove impurities
TROUBLE SHOOTING 14