Brady Handi Quick Start Tutorial page 2

Getting Started With
Your HandiMark
How to Change a Battery Pack
STEP
1
or AC Adapter
CHARGE NEW BATTERY FOR 5 HOURS PRIOR TO USE
(refer to user's manual for more detailed information)
To install a new pack:
a. Make sure the printer is turned off and the battery
lock is in the unlocked position (slide to the left).
b. Insert the battery back in the pocket in the back of
the printer, toward the bottom, and slide it upward.
c. Slide the lock mechanism to the right, or to its
locked position.
d. Verify that the battery is firmly in place.
To remove a battery pack or AC adapter:
a. Make sure the printer is turned off.
b. Slide the battery lock to the left, or the unlocked
position.
c. Grab the battery pack, slide it down and then out.
©2003 All Rights Reserved
1.
®
2.
1. Battery Charger Jack
Connect the charger unit
here. You can charge the
battery pack while it is
either installed or removed
from the label maker.
2. Sliding Lever
Use to lock the battery
pack in place during
installation or to release it
for removal.
3. Power Switch
Turns the label maker "On"
and "Off."
4. Battery Pack
Install as shown.
To install a new ribbon
STEP
3 cartridge:
a. Remove ribbon cartridge from
shrinkwrap, taking care not to
3.
crease the ribbon.
b. Make sure the print
4.
mechanism lock (gray tab)
is in the unlocked, or
down, position. Slide the
ribbon cartridge into the printer as
far as it will go.
c. Move the print mechanism lock to the locked,
or up, position.
How to Unload/Load a Roll of Tape
STEP
4
To remove a roll of tape:
a. Turn the printer off.
b. Open the roll door on the front of the printer.
There is a tab for the door on the right side,
above the ribbon cartridge.
c. Move the print mechanism lock (gray
tab), on the right underside of the
printer, to the unlocked, or down,
position.
2