Kenwood TK-260N Service Manual page 6

10) RF power low
Used to temporarily switch transmission output to low power.
Turning the function on enables:
Hi→Low, Low→Low
Key states are backed up, except in the PC mode when
they are reset.
11) Scan (TK-270G only)
Pressing this key starts scanning. Pressing this key again
stops scanning.
12) Scan Del/Add (TK-270G only)
This key switches the currently displayed channel between
"Delete" and "Add".
The "Add" channel is contained in the scan sequence, the
"Delete" channel is not contained. In the scan mode, this key
switches the channel between delete or add, temporarily.
13) Talk Around (TK-270G only)
Press this key, the transceiver uses the receive frequency
and tone for transmission.
The operator can call the other party directly (without
repeater). Press this key again, the talk around function
goes off.
14) None
An error operation beep sounds, and no action will occur.
Use this function when the transceiver is required to be
operated more simply.
TK-260G/(N)/270G/(N)
OPERATING FEATURES
3. Display (TK-270G only)
4. Scan Operating (TK-270G only)
1) Scan types
that can be selected with the group selector.
groups.
2) Scan Start Condition
channels that can be scanned. The transceiver must be in
normal receive mode (PTT off).
scan starts. The scan icon ("SCN") lights and "SCAN" is
indicated on display.
Icon Description
Not used on this transceiver.
Appears when the selected channel is
busy.
Appears when QT, DQT, DTFM, or 2-
Tone decoding is deactivated (by
pressing the Monitor key).
Appears when you receive a Code
Squelch, Selective Call, 2-Tone, or
DTMF Signalling call. Also appears
when you transmit using Code Squelch
or Selective Call.
Appears while scanning.
Appears when using low power on the
selected channel.
Appears when the selected channel is
included in the scanning sequence.
Displays the selected channel, the
squelch level, DTMF digits (when
entering digits, confirming digits, or
making a call), and messages received
via Selective Call.
Single Group Scan
You can scan all valid (ADD) channels in the displayed group
Multiple Group Scan
You can scan all valid (ADD) channels in all valid (ADD)
One or more non-priority channels must be added to all
When you activate the key programmed to the scan function,
5