Levelling - mabe RMS1540Z Use And Care Manual

levelling

To level the refrigerator use the
two levelling screws found on
the base at the front. Make sure
that the refrigerator is placed
on level ground. Adjust the
levelling screws to ensure that
the refrigerator doesn't move
during day-to-day use.
Turn the screws anti-clockwise
to lift the front of the
refrigerator and clockwise to
lower it.
The front part of the
refrigerator should be a little
higher than the back causing
it to tilt backwards slightly.
Levelling requires two people;
one to tilt the unit backwards
and the other to turn the
screws.
To level it, lift the front by turning the screws until there is a 48 mm (1.9 in)
gap between the floor and the base of the refrigerator, as indicated in the
figure on the right.
observe the following when installing:
important –
after leaving the refrigerator to stand 6 to 8 hours
and before plugging it in:
1. Clean the interior of your refrigerator with a cloth or soft sponge, and a
neutral soap or a soda bicarbonate solution.
2. Plug it in to the correct outlet.
3. Leave it on, empty and closed, for 4 hours before putting food inside.
4. Avoid opening the door before optimum temperature has been
reached.
5. If you want to move your refrigerator to another location, disconnect it.
When it has been repositioned repeat steps 3 and 4.
caution
In the case of physical, mental or sensorial difficulties (including children), or if
you don't have sufficient experience or knowledge to handle this product, you
will need the assistance of a capable adult to ensure safety.
Children should always be supervised. This product is not a toy.
Front
Levelling Front
screws wheels
Front
Front
Levelling Front
screws wheels
Back
wheels
Back
wheels
63