Getting Started; Opening The Housing - Intova EDGE X User Manual

GETTING STARTED

Opening the housing:

Follow the steps below to open the housing. Sometimes a vacuum seal may occur, use thumb press
system to open.
STEP 2
STEP 1
STEP 3
STEP 4
IMPORTANT: Before each use, clean and maintain O-ring by removing any dirt, sand and other
debris and lightly lubricating with silicone grease to prevent drying and cracking.
Inserting the Micro SD card:
Make sure that camera is turned OFF when inserting or removing Micro SD card. Locate Micro SD card
port on your camera (refer to page 4). Insert card with gold contacts facing towards LCD screen. Push
down until card clicks into place. To remove, press down on inserted card to click and then release.
EDGE X uses Micro SD card up to 64 GB. For HD video, speed class 10 is required.
1. The camera cannot record video or take photos without a properly inserted memory card.
2. Format the Micro SD card before use.
3. If the card does not work with the camera, please try another card.
4. When recording video in 1080p, or using WiFi, card speed class 10 is required.
5