Appendix: Using The Io Cable; Using The Input In 1 For Idle Time Reporting; Using The Input In 1 For Changing The Logbook Mode - TomTom LINK 530 Installation Manual

Appendix: Using the IO cable

Using the IO cable, you can record inputs, for example, for keeping a digital logbook with the help
of a switch, reporting times the vehicle is idling, retrieving CANbus data etc. You can connect the
IO cable from TomTom Business Solutions, Art. no. 9KLE.001.02, to the IO cable connector of the
TomTom LINK 530.
CAN High (Orange/Black)

CAN Low (Orange/Brown)

GND (Brown)

IN 1 (Blue/Green)

Digital input can be used for idling reporting and logbook keeping.
IN 2 (Violet)

Digital input
OUT (Green/White)

Digital output

Using the input IN 1 for idle time reporting

Your LINK 530 can report idle times to WEBFLEET when the engine is running for longer than five
minutes and the vehicle is not moving. This requires configuration in TomTom WEBFLEET.
The input IN 1 must be connected to a signal indicating the activity of the
alternator, engine, etc. The input IN 1 must be active when the engine is running.

Using the input IN 1 for changing the logbook mode

Your LINK 530 can report logbook-relevant information to WEBFLEET. Using the input IN 1 you
can change the logbook mode between private and business trips. This requires configuration in
TomTom WEBFLEET.
The input IN 1 must be connected to a switch
the logbook mode is set to Private trip. If no or a low voltage applies to the input IN 1 the logbook
mode is set to Business trip.
indicating the trip mode. If the input IN 1 is active
32
engine, for example