Ford TRANSIT 2015 Owner's Manual page 131

Once operator commanded regeneration
starts, engine rpm will rise to
approximately 2,000 - 2,500 rpm and the
cooling fan will increase speed; you will
hear a change in audible sound due to the
fan and engine speed increase.
It is not necessary to open the hood on the
engine compartment. Once operator
commanded regeneration is complete, the
engine rpm and fan will return to normal
idling. The exhaust system will remain very
hot for several minutes even after
System Message
Message
Exhaust filter over limit
Service now
Operator Commanded Regeneration
with Automatic Regeneration Control
(If Equipped)
If your vehicle is operated with significant
stationary operation, low speed drive
cycles less than 25 mph (40 km/h), short
drive cycles, drive time less than 15 minutes
or the vehicle does not fully warm up,
passive and active regeneration may not
Switching the Automatic Regeneration Control On and Off
To switch the automatic regeneration control on and off, scroll to:
Message
Information
Driver Assist
Auto Exh.Clean
When you switch automatic regeneration off, one of the following warning
messages may be displayed.
Transit (TTH) Canada/United States of America, enUSA, Edition date: 03/2014, Third Printing
Fuel and Refueling
regeneration is complete. Do not reposition
the vehicle over materials that could burn
until the exhaust system has had sufficient
time to cool. Depending on the amount of
soot collected by the diesel particulate
filter, ambient temperature, and altitude,
operator commanded regeneration may
last up to 30 minutes.
and the following message will appear.
Action and Description
You will not be able to allow cleaning. You must have your
vehicle serviced by an authorized dealer.
sufficiently clean the diesel particulate
filter system. You can switch off automatic
regeneration until better driving conditions
are available, for example steady high
driving. You can then switch automatic
regeneration back on to clean the diesel
particulate filter.
Action and Description
Press the OK button.
Press the OK button.
Uncheck the box to switch automatic regeneration off.
Check the box to switch automatic regeneration on.
128
When the system is at the point
of over saturation, the service
engine soon light will illuminate