Troubleshooting - McLean Cooling Technology LOBOY 16 Instruction Manual

Troubleshooting

1. Check manufacturer's nameplate located on the unit for correct power supply.
2. Turn the power to the unit on. The evaporator (Enclosure or "COLD" air) blower should
there airflow?
YES, proceed to step # 3.
NO, possible:
3. Check thermostat setting? Adjust thermostat to the lowest setting. This should turn the condenser
blower and the compressor on. Did condenser blower and compressor come on when the thermostat was
turned on?
YES, proceed to step #4.
NO, possible:
4. Are both blowers and the compressor running? If not the unit will not cool properly.
5. Check condenser (Ambient or "HOT" air) blower for airflow. Is there airflow?
YES, proceed to step # 6.
NO, possible:
6. Carefully check the compressor for operation - motor should cause slight vibration, and the outer case
of the compressor should be warm.
YES, wait 5 minutes, then proceed to step #7.
NO, possible:
7 Make sure the coils are clean. Then check evaporator "air in" and "air out" temperatures. If the
temperatures are the same:
8. To check for a bad thermostat. Turn power to the unit off. Remove control box cover, place both
thermostat wires onto one terminal (replace control box cover for safety). This will bypass the switch in
the thermostat. Turn the power on. If both blowers and the compressor come on, the thermostat needs
to be replaced.
Page 9
Open motor winding
Stuck blower motor
Obstructed wheels/blades
Defective thermostat
Defective thermostat
Open motor winding
Stuck blower motor
Obstructed wheels/blades
Defective thermostat
Defective capacitor
Defective overload
Defective relay
Possible loss of refrigerant
Possible bad valves in the compressor
Repair or Replace
defective parts.
Replace part.
Repair or Replace
defective parts.
Repair or Replace
defective parts.
Repair or Replace
defective parts.
10-1008-05 Rev 1
come on. Is