LIFAN Power USA AXQ1-200A Operating Instructions And Owner's Manual page 9

While engine is running temperature may exceed 150°F (65°C).
Server burns may occur.
Exhaust heat/gasses can ignite combustibles, structures or damage fuel tank causing a
fire.

Do NOT touch hot surfaces and do avoid exhaust gasses.

Allow unit to cool before touching.

Keep at least 6 ft. (183cm) clearance on all sides of unit including overhead clear.

Reflective exhaust heat may damage fuel tank causing fire.

Code of Federal Regulation(CFR) Title 36 Parks, Forests, and Public Property require equipment powered by an internal combustion
engine to have a spark arrester, maintained in working order, complying to USDA Forest service standard 5100-1c or later revision.
In the state of California a spark arrester is required under section 4442 of the California Public resources code.
Unintentional sparking can result in fire or electrical
WHEN TESTING FOR ENGINE SPARK

Do NOT check for spark with the spark plug removed.

Use approved spark plug tester.
WHEN REPAIRING OR ADJUSTING GENERATOR

Disconnect the spark plug wire from the spark plug and place the wire where it cannot contact spark plug.
Improper use and care of this unit will cause damage and shorten its lifespan. Failure to follow these actions will void all

Use unit only for appropriate and designated purposes.

The dealer or customer helpline (1-866-471-7464) can instruct you on intended uses.

Unit must be placed on a level surface.

Do NOT expose unit to extreme conditions. Excessive dust, moisture, and corrosive vapors will damage unit.

Cooling slots must be kept clear of debris.

Do not connect improperly operating devices to unit.

Shut off unit and take to a qualified service center if the unit fails to operate properly.
Safety Instructions (continued)
WARNING!
WARNING!
CAUTION!
LIFAN Power USA
2205 Industrial Park Road
Van Buren, AR 72956
www.lifanpowerusa.com
shock.
warranties.
9
866-471-7464