LIFAN Power USA AXQ1-200A Operating Instructions And Owner's Manual page 13

Pre-Operating Instructions: Assembly
WHEEL KIT INSTALLATION:
The Following Tools are needed to Install Wheel Kit:
 Safety Glasses
 8mm-14mm Wrench Set
 8mm-14mm Ratchet & Socket Set
 17mm Ratchet & Socket
Wheel Kit Installation Directions:
NOTE: Install Wheel Kit BEFORE Filling the Unit with Fuel or Oil. Never Tip a Unit that
contains Fuel or Oil.
1. Attach Flip Up Handle to Mounting Bracket with Flange Bolt and Nut.
2. Attach other Flip Up Handle using Flange Bolt and Nut.
3. Tip Unit so Engine End is up.
4. Slide Axle through both Mounting Brackets.
5. Place a Wheel on Both Sides as shown in "Assembly Diagram."
6. Securely Tighten Wheel Nuts with the 17mm Socket.
7. Tip the Alternator End of the Unit up.
8. Place the Support Legs under the Frame Brace as shown in "Assembly Diagram."
9. Secure with the provided Cap Screws and Hex Nuts. Securely tighten using
12mm Ratchet and Socket.
(continued)
Refer to Assembly Diagram.
13
LIFAN Power USA
2205 Industrial Park Road
Van Buren, AR 72956
866-471-7464
www.lifanpowerusa.com