JVC GR-AX18EG Instruction Manual page 12

Tape remaining time indicator
25MIN
Start/Stop Button
4
MIN
(Now calculating)
60MIN
NOTES:
59MIN
3MIN
2MIN
(Blinking)
1MIN
(Blinking)
0MIN
(Blinking)
STOP RECORDING
Press the Recording Start/Stop Button again to stop
recording.
•The camcorder re-enters the Record-Standby
mode.
When the Power Switch is set to CAMERA and the LCD
monitor is opened at an angle of 45 degrees or more, the
LCD monitor switches on and the viewfinder switches
off automatically to save power.
A cassette holder can't be opened unless a power supply
is attached.
There may be a delay after you press EJECT until the
holder opens. Do not use force.
The tape remaining time is only displayed in the
viewfinder as shown.
The remaining time indicated in the viewfinder is
approximate.
The time required to calculate the remaining tape
length, and the accuracy of the calculation, may vary
according to the type of tape used.
The tape remaining time indicator is correct only if the
correct tape length has been selected (
"TAPE END" appears when the tape reaches its end,
and the power goes off automatically if left in this
condition for 5 minutes. "TAPE END" also appears
when a cassette whose tape is already at its end is
loaded.
If the Record–Standby mode continues for 5 minutes
without performing Zoom or any other operations, the
camcorder's power shuts off automatically. Set the
Power Switch to "POWER OFF", and then back to
"CAMERA" to turn the camcorder on again.
If the Recording Start/Stop Button is pressed after the
Record-Standby mode has continued for over
5 minutes, recording may not start immediately.
If you're recording on a cassette from the middle (such
as when a tape is removed and re-inserted during
recording), use the Retake function (
the end of the last recording so you don't erase any of
it.
The LENS COVER warning blinks for about 5 seconds
when the camcorder is turned on when the cover is
closed.
While shooting, sound is not heard from the speaker.
13
EN
pg. 8).
pg. 17) to find