Installing and Configuring the Windows NT Driver
5.1
New Spectrum24 Adapter Installation
22
To install the Spectrum24 driver for the first time in
Windows NT:
Verify there is no existing Spectrum24 Windows NT
driver in the system. If there is an existing Spectrum24
Windows NT driver, remove it and complete the
instructions in this section.
If IRQ or I/O conflicts occur during the installation,
configure the IRQ and I/O addresses for available
values. Refer to the Windows NT Diagnostics Tool to
verify the values. Use the NCPA WLAN Adapter page
to set the Interrupt Number, the I/O Port Address and
the Memory Base Address values.
1. Install the Spectrum24 WLAN adapter as
described in Chapter 3.
2. Power up the system.
3. Insert the Spectrum24 Windows driver
installation CD.
4. Click Start, select
5. Click on the
Adapters
tab. Click Add.
6. Click
Have
A window appears prompting for the location
of the driver files.
Spectrum24 Wireless LAN Adapter Product Reference Guide
Settings
Network
icon and select the
Disk.
and
Control
Panel.