OPTION 2
• Open freezer door to 90°.
For dispenser
• Remove the Phillips head screws from the full-length
model using
full-width
• Open door fully to stop.
trim
• Remove screws from the aluminum trim, top, bottom
Step 1
• Remove the trim above and below the dispenser.
Remove
• Retain screws and full-length handles. Discard
handles & trim
Step 2
• Attach the new 3/4" trim pieces at the top and hinge
Install
3/4" trim
Step 3
• Position and mark the location for the support
Install panel
support brackets
• On the bottom of the upper panel, measure
• On the bottom of the lower panel, measure
• On the top of the lower panel, measure dimension C
• Secure all brackets with #4 screws provided.
Dimension A
ZKT48–6"
handles.
and hinge side.
original trim.
side using original screws.
brackets on the back side of the panels. Align all
brackets flush with the end of the panels, with tabs
protruding over the edge.
dimension A from the hinge side.
dimension B from the hinge side.
from the hinge side.
Dimension B
ZKT48–8-3/4"
ZKT48 Trim Kit
3/4" Custom Panels
Back Side
of Freezer
Panels
Dimension C
ZKT48–6"
C
Hinge
Side
Upper
Panel
Lower
Panel
A
B
31