DAGE-MTI Excel Series User Manual page 38

B. If your Laptop computer does not have an IEEE-1394 port, then you will need to install an
"IEEE-1394 PCMCIA CardBus" card and use a standard 6-pin to 6-pin cable along with a
"12 Volt Power Supply" to power the camera and connect the IEEE-1394 bus. The IEEE-
1394 Card, Cable and Power Supply are available as a kit. (Dage P/N 207744-03)
1. Install the PCMCIA CardBus card into your Laptop.
2. Windows XP will automatically install the driver for the card. Reboot computer if
prompted.
3. Install the Exponent software Application. (Directions start on Page-8)
4. Connect the Camera to the CardBus card using a 6-pin to 6-pin IEEE-1394 cable.
5. Start the Exponent Software application and then connect the Power Supply to the
"EXT PWR" connector on the camera.
6. Install the camera driver following the "Exponent Software Camera Driver Install"
method. (Directions start on Page-13)
7. Begin using your camera.
LAPTOP
POWER
SUPPLY
IEEE-1394
Cable
6-PIN
CardBus
Card
38
EXCEL
CAMERA