Hi, Lo) Transmit Power; Atis Active; Turning The Power On And Off; Setting The Volume - Raymarine Ray49E Owner's Handbook Manual

Marine vhf radio

Hide thumbs Also See for Ray49E:

Table of Contents

14. (HI, LO) Transmit Power

Indicates whether radio tranmissions are being made at 25 watts (HI) or 1 watt

(LO).

Indicates ATIS transmission is enabled. If enabled on your radio, this feature is

only available in European countries using the International channel set.

Turn the PWR/VOL knob clockwise until it clicks.

When the unit powers up in standby mode it:

• Beeps, illuminates the backlight at full brightness, and displays a self-test.

• Recalls the last channel number, TX power settings and operation mode.

If no last-used setting data exists, goes to channel 16 and high TX Power.

• When GPS Data is available, extended position data is displayed with the off-

set time. This information will be displayed when display option for the posi-

tion and time is enabled on the Menu. See Section 4.3.

• When the MMSI number is not programmed, you are prompted to enter the

number as described on page 87. You must then press CH/OK to continue.

To turn the unit OFF, rotate the PWR/VOL knob completely counter clockwise

until it clicks.

Adjust the PWR/VOL knob to control the loudspeaker volume level. Turn

clockwise to increase the volume; counter clockwise to decrease the volume.

The squelch circuit sets the threshold for cutting off the receiver when the signal is

too weak for reception of anything but noise. To properly set the squelch, rotate

the SQ knob counter clockwise until audio is heard. Then rotate clockwise until

background noise disappears.

Ray49E Marine VHF Radio

Table of Contents