4 Replacement Procedures
LCD FL cable
Installing the Display Assembly
Install the display assembly according to the following procedures and Figures 4-15, 4-16.
1. Place the display panel in the correct position and push the wireless antenna cable
into the top cover.
2. Connect the LCD/FL cable to CN3 on the system board.
3. Connect the CCD cable to CN7 on the system board.
4. Connect the MIC cable from MIC extended cable.
5. Secure the display assembly with four M2.5x8 black flat head screws.
6. Close the display panel and turn the computer so the back is facing you and secure
two M2.5x5 black flat head screws.
4-32
Satellite A210/A215/Satellite Pro A210/EQUIUM A210/SATEGO A210 Maintenance Manual
/
Wireless LAN antenna
CN3
MIC connector
Figure 4-16 Removing the display assembly
M2 5x8 black flat heat screw
.
-
MIC cable
CN7
4.8 Display Assembly
CCD cable