Installing The Display Assembly - Toshiba Satellite L670D Maintenance Manual

4.11 USB Board

Installing the Display Assembly

Install the display assembly according to the following procedures and Figure 4.28.
1. Seat the display hinge brackets in the correct position on the logic lower assembly and
secure it with four M2.5x5 screws.
2. Connect the LVDS cable to the motherboard and adhere the clear tape over the connector
to secure it in place.
3. Route the two antenna cables and the LVDS cable into the routing channel on the logic
lower assembly, and attach the tape over the cables to secure them in place.
tape
tape
Figure 4.28 Installing the display assembly
[CONFIDENTIAL] Satellite L670D/L675D/Pro L670D Maintenance Manual
4 Replacement Procedures
tape
tape