Utilitech 006220B User Manual page 5

4. Make sure wire connections are secure. Carefully place wires
into junction box. Position the light fixture (A) cover plate over
the crossbar (EE).
Note: Long mounting screw (AA) and short mounting screw
(BB) are provided for differences in screw hole depth. Put
either long mounting screw (AA) or short mounting screw (BB)
through the center hole and into the crossbar (EE) and tighten
the screw until secure. Insert mounting screw cap (FF) into
mounting screw hole. DO NOT overtighten.
Hardware Used
Long mounting screw
Short mounting screw
Mounting screw cap
IMPORTANT: After mounting thefixture light, apply silicone caulking compound
around the perimeter of the cover plate where the back of the cover plate meets the mounting
surface. Silicone caulking prevents water from seeping into the junction box.
Your installation is now complete. Turn on power at circuit breaker and flip wall switch to ON
position. Wall switch must remain in the ON position for the motion detector to work properly.
x 1
x 1
x 1
5
completely