Checking The Xm Signal Strength And Radio; Searching Categories; Ipod ® Playback; Basic Operation - Denon AVR-888 Owner's Manual

Checking the XM Signal Strength and
Radio ID
1
<SOURCE SELECT>
Either turn or press
select "XM".
2
STATUS
Press until "SIGNAL" appears on the
display.
The display will switch as shown below, depending on the
reception conditions.
Display Status
GOOD Signal strength is good
Signal strength is marginal
MARGINAL
WEAK Signal strength is weak
NO No signal
3
Adjust the position of the antenna until "SIGNAL:
GOOD" is shown on the display.
4
STATUS
Press until the station you want to check
(example: "XM001") is displayed.
5
TUNING
Press and select channel 0 (XM000).
The radio ID is shown on the display.
Radio ID
The strength of both the XM satellite and terrestrial signals can be
checked at menu "Input Setup" – "Antenna Aiming" (vpage 36).

Searching Categories

1
Press o p .
[SAT TU]
to
2
Use o p to select the category, then use
the desired station.
iPod ® Playback
The music on an iPod can be played by using the Control Dock for
iPod (ASD-1R, ASD-3N or ASD-3W, sold separately).
The operation can also be performed using the buttons on the main
unit or remote control unit while watching the menus.
iPod is a trademark of Apple Computer, Inc., registered in
the U.S. and other countries.
b The iPod may only be used to copy or play contents that are not
copyrighted or contents for which copying or playback is legally
permitted for your private use as an individual. Be sure to comply
with applicable copyright legislation.

Basic Operation

1
Make the necessary preparations.
q S et the iPod in the DENON Control Dock for iPod.
Channel category (vSee the Control Dock for iPod's operating instructions.)
w Assign the Control Dock for iPod's input.
ui to select MENU : "Input Setup" – "Assign" – "iPod dock"
(vpage 35)
2
Either turn
select the input source assigned in step 1-w above.
b If the screens above are not displayed, the iPod may not be
properly connected. Try connecting again.
3
[MODE SELECTOR 1]
Set
SELECTOR 2]
(vpage 50 "Remote Control Unit Operations")
• With the default settings, the iPod can be used connected to the VCR
(iPod) connector.
• Use the RESTORER mode to expand the low and high frequency
components of compressed audio fi les and achieve a richer sound.
The default setting is "Mode3" .
• Press <ON/STANDBY> and set the AVR-888's power to the standby
mode before disconnecting the iPod. Also switch the input source
to one to which the menu "iPod dock" is not assigned before
disconnecting the iPod.
NOTE
• Depending on the type of iPod and the software version, some
functions may not operate.
• DENON will accept no responsibility whatsoever for any loss of iPod
data.
• When using an ASD-3N or ASD-3W Control Dock for iPod, refer to
the respective manual to operate.
ENGLISH
<SOURCE SELECT> [iPod]
or press
OK to disconnect.
(iPod screen)
[MODE
to "AUDIO" and
to "iPod/NETWORK".
to