Declaration Of Conformity; Troubleshooting Guide; After Sales Service - Whirlpool Built in oven User Manual

Energy saving
- Only pre-heat the oven if specified in the cooking table or your recipe. Induction functions do not
require pre-heating.
- When cooking using induction mode, use the supplied cooking vessel which is designed to maximize
energy saving.
- Use dark lacquered or enamelled baking moulds as they absorb heat far better.
- In standard (non-induction) mode, switch the oven off 10/15 minutes before the set cooking time.
Food requiring prolonged cooking will continue to cook even once the oven is switched off.

DECLARATION OF CONFORMITY

- This oven, which is intended to come into contact with foodstuffs, complies with European
Regulation ( ) n.1935/2004 and has been designed, manufactured and sold in conformity with the
safety requirements of the "Low Voltage" directive 2006/95/CE (which replaces 73/23/CEE and
subsequent amendments), the protection requirements of "EMC" 2004/108/CE.
- This Appliance meets the eco design requirements of European regulations n. 65/2014, and
n. 66/2014 in conformity to the European standard EN 60350-1.

TROUBLESHOOTING GUIDE

The oven does not work:
• Check for the presence of mains electrical power and if the oven is connected to the electrical supply.
• Turn off the oven and restart it to see if the fault persists.
The electronic programmer does not work:
• If the display shows the letter " " followed by a number, contact your nearest After-sales Service.
Specify in this case the number that follows the letter " ".
The induction plate does not work:
• The induction plate must be used on the third shelf position only; ensure it is correctly positioned and
fully connected.
• Turn the oven off and then on again. Check if the fault persists.
AFTER-SALES SERVICE
Before calling the After-Sales Service:
1. See if you can solve the problem yourself with the help of the suggestions given in the
"Troubleshooting guide".
2. Switch the appliance off and back on again to see if the fault persists.
If after the above checks the fault still occurs, get in touch with the nearest After-sales Service.
Always specify:
• a brief description of the fault;
• the type and exact model of the oven;
• the service number (number after the word Service on the rating plate), located on the right hand
edge of the oven cavity (visible when the oven door is open). The service number is also indicated
on the guarantee booklet;
• your full address;
• your telephone number.
If any repairs are required, please contact an authorised After-sales Service (to guarantee that original
spare parts will be used and repairs carried out correctly).
EN6