Remote Control Unit - JVC 0797TOV*UN*VP Instructions Manual

Remote Control Unit

You can use the RM-V711U to control the camcorder. When using the remote control, be sure to point it at
the remote sensor. The transmitted beam effective area for indoor use is approx. 5 m. The transmitted beam
may not be effective or may cause incorrect operation if the remote sensor is directly exposed to sunlight or
powerful lighting.
PAUSE IN connector (
Zoom Buttons (
DISPLAY Button (
SHIFT Button (
SLOW Rewind/Forward
Buttons ( pg. 49)
Left/Right Buttons
( pg. 50)
FADE/WIPE Button
( pg. 61)
EFFECT Button
( pg. 51)
EFFECT ON/OFF Button
( pg. 51)
Knob
START/STOP Button (
pg. 60)
pg. 50)
pg. 65)
T
pg. 50)
R.A. EDIT Buttons (
pg. 66)
W
pg. 61)
Installing The Battery
The RM-V711U uses one lithium battery (CR2025).
1
PULL OUT BATTERY HOLDER
Pull out in the direction of the arrow while
pressing the knob as shown.
2
INSERT BATTERY IN HOLDER
Insert the battery in the holder, and be sure to
have the "+" mark visible.
3 RE-INSERT HOLDER
Slide the holder back in until you hear a click.
•Read the caution concerning lithium batteries
( pg. 2).
EN
AUDIO MONITOR Button
( pg. 65)
MBR SET Button ( pg. 59)
A. DUB Button ( pg. 65)
Down Button ( pg. 50)
INSERT Button ( pg. 66)
Up Button ( pg. 50)
Operation Buttons
( pg. 50, 66)
17