First Alert FA168CPS User Manual page 26

3DJLQJ)HDWXUH
$ERXW$XWRPDWLF3DJLQJ
Your system may be set up to automatically send alert messages to several pagers (up
to four for FA168CPS, up to two for FA148CP) as certain conditions occur in your
system.
• The following events can be programmed by your installer to be sent to the pagers:
arming and disarming
arming/disarming from a keypad using a security code; auto-arming/disarming,
arming with assigned button, and keyswitch arming do not send pager messages.)
• You can also program the system to send an automatic pager message to alert you
in the event that someone has not arrived home (disarmed the system) within a
defined period of time (see the Scheduling section for details on programming a
"latch key report").
• Your installer programs the pager phone numbers and reporting events.
• The pager message consists of a 7-digit system status code that indicates the type of
condition that has occurred.
• An optional, predefined 16-digit character string can precede the 7-digit system
status code; these characters can consist of a PIN no., subscriber account no., or any
additional data that you may wish to have sent to the pager.
• The pager display format is as follows:
Optional 16 digits
È È
AAAAAAAAAAAAAAAA – BBB – CCCC
A =
Optional 16-digits for
Account numbers,
PIN numbers, or any
other data;
programmed by the
installer, if required.
The 3-digit Event Codes (BBB) that can be displayed are:
911 =
Alarms.
The 4-digit number
(CCCC) following this
code is the partition no.
and zone no. that
caused the alarm.
Ex. 1.   ³    
Ex. 2.    ³     = Reporting of a closing–system arming (102)– by user 5 in Partition 2 (2005).
– 26 –
, alarms, and trouble conditions. (
†
3-digit Event Code
È È
B =
A 3-digit code that
describes the event
that has occurred
in your system
(see for event
codes table below)
811 =
Troubles.
The 4-digit number
(CCCC) following this
code is the partition no.
and zone no. that
caused the trouble.
= R eporting of an alarm (911) caused by a fault on zone 4 on Partition 1 (1004).
†
Å Å
1-digit Partition No. + 3-digit Zone No. or User No.
A 1-digit Partition number plus a 3-digit Zone or User
number, depending on the type of event that has
occurred, where:
• alarms and troubles display zone number
• arming/disarming (opens/closes) display user number
101 =
Open
(system disarmed).
The 4-digit number
(CCCC) that follows
this code is the
partition no. and user
no. that disarmed the
system.
reports when
C =
102 =
Close
(system armed).
The 4-digit number
(CCCC) that follows
this code is the
partition no. and user
no. that armed the
system.