Lotus 2004 ELISE Service Notes page 62

Lotus Service Notes
Door glass
slider block
Door glass
stud plate
6. Adjust the glass upstop postion, top edge alignment and inward tilt as detailed above.
Door glass guide rails
Two guide rails are used for door glass; one for the front and one for the rear edge. Each of the steel,
black zinc plated, guide rails, is secured by a single screw at the top end to a jig bonded bracket in the door
shell, and by a threaded adjuster at the lower end, engaging in a threaded block fixed to the door shell.
Screwing the adjusters in or out will set the inward tilt of the glass and the contact between glass and door
weatherseal.
To remove a guide rail, first remove the door glass (see above), before releasing the single screw at the
top, and releasing the threaded block from the door shell.
Lift channel
Reaction
channel
Winder mechanism
Scissor arm
pivot fixing
Section BR
b321
Winder
mechanism
fixing
Page 19