Lotus 2004 ELISE Service Notes page 224

Lotus Service Notes
After verifying this dimension, any slack in the rear cable may be adjusted out at the left hand outer cable
abutment, which is integral with the pivot bracket for the front leg of the lower wishbone. Remove the engine
bay undertray for access. After adjustment, re-check the calliper lever 'off' dimension.
LH lower wishbone
front pivot bracket
Parking brake cable adjuster
The parking brake lever is mounted in a steel bracket which also houses the gearchange lever, and is
bolted to the seat mounting crossmember at the front, and to the floor rear crossmember. The parking brake
lever is secured by two bolts fixing the ratchet quadrant to the bracket. Access to the lever is available after
removing the cockpit centre trim panel:
Ratchet quadrant
Parking brake tell tale switch
Mounting bracket
Page 10
Horseshoe compensator
Parking brake lever
Section JJ
Primary cable
Fixing point to
seat rear
crossmember
j169
j189