Lotus 2004 ELISE Service Notes page 101

Lotus Service Notes
8. Tighten the turnbuckle locknuts to 45 Nm whilst holding the adjacent adaptor lug, and then tighten the
engine steady mountings to 45 Nm.
9. Adjust rear wheel alignment only at mid-laden ride height of 130mm to 1.5mm toe-in each side (±
0.3mm) and tighten the toe-link ball joint locknuts to 45 Nm. Ensure ball joints are phased at 90° to each
other to allow maximum joint articulation.
10. Refit undertray and diffuser.
Viewed from below
FRONT
Toe-link
Section A thro' lower
link inboard fixing
Lower wishbone
rear bush
FRONT
Self-locking nut
Page 12
Adaptor lug Turnbuckle
New spherical
joint
Welded insert
Adjustable type cross-brace tube
Heatshield
Adaptor lug
Pivot bolt
New spherical joint
Special spacer washer
Section DH
Brace to
chassis
d48
d46a