Summary of Contents for Next generation Booster Seat
Page 1
IMPORTANT: KEEP THIS BOOK IN THE PLACE PROVIDED ON THE CHILD RESTRAINT To be used with either a lap-sash seat belt or an add-on accessory Child Harness by children whose shoulders are above the lower shoulder height marker with head restraint in lowest position (approximately 4 years of age) until child’s shoulders reach the upper shoulder height marker with head restraint in highest...
Page 2
6 to 8 years of age in vehicles using a lap-sash seat belt or INTRODUCTION with a seat belt and Child Harness. The Booster Seat must not be used with just a lap only seat belt as the upper body of the child is not protected. It must be used WARNINGS with a lap-sash seatbelt.
Page 3
• Use the restraint exactly as shown in the instructions. • Straps may be damaged by unsecured cargo in a collision. Secure or remove hazardous cargo before using this strap. Hatch-back or wagon: Do not use the • Supervision of children is needed because they may be able to undo buckles and child restraint where this strap may fall into a split in the seat back.
Once the child no longer fits, move to the next form of child restraint, see page 29. Note: These heights also apply if you are using a Child Harness with this Booster Seat. Front of Vehicle...
Page 5
FEATURES FEATURES Car’s Anchor Fitting Adjustable Height Headrest Padded Cover for Comfort Car Seat Belt Armrest (on each side) Booster Belt Path Label (each side) Headrest Adjustment Knob Shoulder Height Markers Shoulder slots for use with Child Harness Seat Belt path label & Sash Guide (each side of headrest) Upper Anchorage Strap Adjuster Upper Anchorage Storage Band Adjustable Upper Anchorage Strap...
Continue to use this child restraint until child reaches the limit. Children are safest vehicle to adjust the headrest. in a Booster Seat until their shoulders reach the upper shoulder height marker of Pull out the knob located on the back of the the Booster Seat.
(refer to page 11). headrest may also interfere with the the webbing is thick Position the Booster Seat in the car facing forward routing of the upper anchorage strap. enough to be held in in the chosen seating position.
Disengage seat belt tongue and buckle. Remove belt If the seat belt buckle is adjustable, adjust from child. When Booster Seat is not being used, the buckle as low as possible away from secure in position, by engaging seat belt over the the child.
Page 9
BL220/2010. Refer to the instruction book supplied with the Child Harness for full details of using and installing the Child Harness. When installing the Child Harness into the vehicle and Booster Seat, connect the upper anchorage strap to the VERSATETHER™ Catch on the Booster Seat’s upper tether strap (as shown below).
Page 10
Ensure that none of the straps are twisted or catching on Method 2 - Using lap seat belt. sharp edges. Tighten the Booster Seat’s upper anchorage strap (refer to page 12) then remove excess slack from the extension strap by pulling the adjuster strap as Before installing the Harness determine which method of installation is required illustrated below.
Page 11
Booster Seat cover. Neck Slots in cover Pass the left hand Strap and Attachment Clip through the right Booster hand slot Seat’s upper anchorage strap Rear view of Booster Seat showing harness straps feeding through the headrest cover slots...
Page 12
HOW TO USE HOW TO USE USE WITH CHILD HARNESS USE WITH CHILD HARNESS METHOD 1: USING LAP-SASH SEAT F. Hook the harness Attachment Clip onto the VERSATETHER™ Catch. BELT WITH CHILD SAFETY HARNESS. Outer Refer to the Harness instructions for strap.
Page 13
HOW TO USE HOW TO USE USE WITH CHILD HARNESS USE WITH CHILD HARNESS FITTING THE GATED SLIDE TO THE LAP-SASH SEAT BELT D. Feed the straps through the Gated Slide to remove any slack. A. Hold the lap and sash straps together and fold as shown right.
Page 14
Also ensure there 5. Right Hand Harness Strap Loop are no twists in the harness, cross 6. Cross Strap Loop strap and seat belt 7. Cross Strap 8. Booster Seat Upper Anchorage Strap 9. Car’s Anchor Fitting...
Once the child is too large for the Booster Seat , the Child Harness can still be used and is a significant safety device for children in a lap only seat belt. Refer to the Child Harness instruction book.
(A). 3. Align and fit center cover over backrest. 4. Re-attach hook and loop (B). 5. You will need to fit the Booster Seat back in the car and attach the upper anchorage strap. Adjust the headrest.
Page 17
PRE-INSTALLATION OF PRE-INSTALLATION OF ANCHOR FITTING ANCHOR FITTING Consult the vehicle owner's handbook for location of anchorage fittings or Extension Strap distance to be measured. anchorage points and the possible use of spacers. Some vehicles may have an Length 300mm (Use Safe-n-Sound part 0035 or equivalent) anchor fitting fitted by the vehicle manufacturer.
Page 18
PRE-INSTALLATION OF PRE-INSTALLATION OF ANCHOR FITTING ANCHOR FITTING IF THE CAR IS FITTED WITH CHILD Note to Queensland purchasers: The installation of anchorage points must be UPPER ANCHORAGE FITTING RESTRAINT ANCHORAGE POINT approved by authorised officers appointed by Queensland Transport. Authorised Locate the anchorage point behind the officers can be sourced from all Queensland Transport Customer Service and Fig.1.
If your restraint has been involved in a severe crash, you should destroy the restraint even if no damage is obvious. Some insurance companies offer vehicle Booster Seat. insurance which covers or partially covers the replacement of your child restraint.
Need help?
Do you have a question about the Booster Seat and is the answer not in the manual?
Questions and answers