Installation Step By Step; Built Under Installation; Check List Before Using The Dryer; Preparing To Transport The Dryer Step By Step - Bosch WTE86300US Operating, Care And Installation Instructions Manual

Installation
step by step
1. Unpack the dryer.
2. Remove all objects from the
drum.
3. Check the dryer for visible
damage.
4. Position the dryer near the
installation location.
5. Have the power supply cord
fitted by an authorized
technician (see page 8).
6. Move the dryer to its final
location and align.
CAUTION
Do not slide dryer across the
floor if height adjustable feet
have been extended. Feet and/or
dryer base may be damaged if
dryer is slid across floor with
height adjustable feet extended.
7. Position and then level the
dryer .
The dryer should be level with
all four feet firmly on the
ground. The dryer must not
wobble.
If the dryer is not level or if it
does wobble, the feet must be
adjusted. Adjust the
height adjustable feet until the
dryer does not rock and is level,
both front to back and
side to side.
8. Insert plug into the wall
receptacle.

Built under Installation

The appliance can be built
under; that is, you can install the
dryer under counter in a kitchen
cabinet opening. The cabinet
opening should be square and
have dimensions as shown in the
figure.
a 600 mm minimum // 23
b 600 mm minimum // 23
c 850 mm minimum // 33
i
If installed under a countertop,
the countertop must be
continuous and securely
attached to neighboring
cabinets.
CAUTION
An opening of at least 31 square
2
inches (200 cm ) must be avail
able at the front and side of the
closet.
Check list before
using the dryer
1. Check that steps 1 8 have
been implemented properly.
2. Ensure that the dryer is
connected to the power supply.
3. Read the operating instructions
to understand how your dryer
operates.
4. Conduct an appliance test:
q Check that the drum is
empty.
q Close the dryer door.
q Switch the dryer to Extra
Dry" and then press the
Start button.
q After 3 5 minutes press the
Stop button and open the
door.
5. If the interior of the dryer feels
warm, the dryer has been
connected properly.
Switch the dryer to OFF".
6. If the dryer does not work,
switch the dryer to OFF".
Look in the troubleshooting
section (page 21) of the
OPERATING INSTRUCTIONS
and find the fault.
Preparing to transport
the dryer
by step
5
/ "
8
1. Rotate the program selector
5
/ "
8
to OFF".
1
/ "
2
2. Pull out power supply plug.
3. Place any accessories in the
drum.
4. Close the door and secure with
adhesive tape.
5. Screw the height adjustable
feet of the dryer into the
housing to prevent them from
being damaged during
transportation.
step
11