Bush DW12-TFE3 Series Instruction Manual page 5

Water remains inside appliance after programme has ended.
Blockage or kink in drainage hose.
Pump is jammed.
Filters are blocked.
The programme is still running. Wait for the programme to end.
...during washing
Unusual amount of foam is created
Normal washing up liquid has been poured into the rinse-aid container.
Remove any spilled rinse aid with a cloth as it could otherwise lead to excessive foaming during the
next washing cycle.
Appliance stops suddenly while washing is taking place
Electricity supply has been cut off to appliance.
Water supply has been interrupted.
Knocking sound can be heard while washing is taking place
A spray arm is knocking against the dishes inside the appliance.
Rattling sound can be heard while washing is taking place
Crockery has not been stacked properly inside the appliance.
Knocking sound coming from inlet valves
This is caused by the way the water pipes have been laid and it has no effect upon the way the
appliance functions. There is no remedy for this.
...with the dishes,cutlery, etc.
Food residue is stuck to the dishes, cutlery, etc.
Dishwasher was not loaded properly. Jets of water could not reach all parts of the dishes, etc.
Too many items in the rack.
Items in the rack were touching each other.
Not enough detergent was added to dispenser.
Selected wash programme was not intensive enough.
Rotation of spray arm was obstructed by dishes, etc.
Nozzles in spray arm are blocked by food residue.
Filters are blocked.
Filters have been incorrectly fitted.
Waste-water pump is jammed.
BUSH Dishwasher User Manual
23
Customer Helpline 0845 600 4632
Installation
Positioning the appliance
Positioning the appliance in the desired location. The appliance is equipped with water supply and drain
hoses that can be positioned to the right or the left of the appliance to facilitate proper installation.
Levelling the appliance
Once the appliance is positioned, adjust the feet (screwing them in or out) to level the appliance. If the
appliance is level, it will help to ensure proper performance.
Cold water connection
Connect the water supply hose to a threaded 3/4 inch (ca. 19mm)
connector, making sure that it is fastened tightly in place (see
Fig. A).
If the water pipes are new or have not been used for an extended
period of time, let the water run for a while until the water is clear
and free of impurities.
If this precaution is not taken, there is a risk that the water inlet
can get blocked and damage the appliance.
Warning
The appliance is to be connected to the
mains water using new hose sets. Old
hose sets should not be reused.
Anti-Flooding protection
The dishwasher is equipped with a system that stops the supply of water in the event of a problem with
the water supply hose or leaks within the unit, in order to prevent damage to your home. If for any reason
the box containing the electrical components happens to get damaged, turn off the power supply and
unplug the appliance immediately. In order to guarantee that the anti-flooding feature operates properly,
box "A" with the water supply hose must be attached to the water supply tap as shown in Fig. B. If the
length of the hose is not adequate to make a proper connection, the hose must be replaced with one
which is long enough. This hose is available upon request from specialised retailers and approved ser-
vice centres.
BUSH Dishwasher User Manual
fig.A
fig.B
Customer Helpline 0845 600 4632
4