Juniper J-series Services Router J4350 Getting Started Manual page 204

J2320, J2350, J4350, and J6350 Services Router Getting Started Guide
Figure 82: Alternative Horizontal Orientation of J4350 and J6350 Compact Flash
To replace the compact flash:
1.
2.
3.
4.
5.
6.
WARNING: If the fans are still rotating, wait until they stop before proceeding with
the next step, especially if your compact flash is in the horizontal position (flat against
the system board).
7.
182
Replacing Internal Compact Flashes on J4350 and J6350 Routers
Place an electrostatic bag or antistatic mat on a flat, stable surface.
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist and
connect the strap to the ESD point on the chassis, or to an outside ESD point if
the router is disconnected from earth ground. For more information about ESD,
see "Preventing Electrostatic Discharge Damage" on page 251.
Press and release the power button to power off the router. Wait for the
LED to turn off.
Remove the power cord or cable from the power source receptacle.
Remove the screws from the sides and top of the chassis that secure the cover
to the chassis.
Slide the cover off the chassis.
Slide the compact flash out of its slot, as shown in Figure 83 on page 183.
POWER