Ac Power, Connection, And Power Cord Specifications - Juniper J-series Services Router J2320 Getting Started Manual

Table 48: AC and DC Power System Electrical Specifications for J2320 and J2350 Routers
Item
AC input voltage
AC input line frequency
AC system current rating
DC input voltage
DC system current rating
Table 49: AC and DC Power System Electrical Specifications for J4350 and J6350 Routers
Item
AC input voltage
AC input line frequency
AC system current rating
DC input voltage
DC system current rating

AC Power, Connection, and Power Cord Specifications

NOTE: The AC power cord for the Services Router is intended for use with the router
only and not for any other use.
Detachable AC power cords, each 2.5 m (approximately 8 ft) long, are supplied with
the Services Router. The appliance coupler at the female end of the cord inserts into
the appliance inlet on the faceplate of the AC power supply. The coupler is type C19
as described by International Electrotechnical Commission (IEC) standard 60320.
The plug at the male end of the power cord fits into the power source receptacle that
is standard for your geographical location.
NOTE: In North America, AC power cords must not exceed 4.5 m (approximately
14.75 ft) in. length, to comply with National Electrical Code (NEC) Sections 400-8
(NFPA 75, 5-2.2) and 210-52, and Canadian Electrical Code (CEC) Section 4-010(3).
The cords supplied with the router are in compliance.
Specification
100 to 240 VAC nominal
50 to 60 Hz
J2320 Services Routers: 3.2 A to 1.3 A
J2350 Services Routers: 3.5 A to 1.5 A
–48 to –60 VDC operating range
7.2 A
Specification
100 to 240 VAC nominal
50 to 60 Hz
J4350 Services Routers: 6 A
J6350 Services Routers: 8 A
–48 to –60 VDC operating range
20 A
Power Guidelines, Requirements, and Specifications
Chapter 5: Preparing for Router Installation
107