Power Outlet; Uconnect™ Phone - Jeep 2010 Patriot User Manual

2010 patriot
Hide thumbs Also See for 2010 Patriot:
Table of Contents

Advertisement

ELECTRONICS

POWER OUTLET

• The power outlet is located on the instrument panel below the climate control and is
powered when the ignition switch is in the ON position.
• The outlet can operate a conventional cigar lighter unit or power accessories designed
for use with a standard power outlet adapter.
NOTE: Do not exceed the maximum power of 160 Watts (13 Amps) at 12 Volts. If the 160
Watt (13 Amp) power rating is exceeded the fuse protecting the system will need to be
replaced.
Uconnect™ Phone
• The Uconnect™ Phone is a voice-activated, hands-free, in-vehicle communications
system.
• The Uconnect™ Phone allows you to dial a phone number with your cellular phone using
simple voice commands.
• For vehicles equipped with Video Entertainment System (VES)™, refer to the Uconnect™
Phone section of the Uconnect™ User's Manual on the DVD for further details.
• For vehicles not equipped with VES™, refer to your vehicle Owner's Manual on the DVD
for further details.
• Any voice commanded system should be used only in safe driving conditions
following local laws and phone use. All attention should be kept on the roadway
ahead. Failure to do so may result in an accident causing serious injury or death.
• Your phone must be turned on and paired to the Uconnect™ Phone to allow use of
this vehicle feature in emergency situations, when the cellular phone has network
coverage and stays paired to the Uconnect™ Phone.
NOTE: The Uconnect™ Phone requires a cellular phone equipped with the Bluetooth®
Hands-Free Profile, Version 0.96 or higher. For Uconnect™ customer support, call
1–877–855–8400.
Phone Pairing
NOTE: Pairing is a one-time initial setup before using the phone. You will also need to
follow the Bluetooth® instructions in your cell phone user guide to complete the phone
pairing setup.
• Press the Phone button
• Wait for the "ready" prompt and beep.
• (After the BEEP), say "Uconnect setup".
• (After the BEEP), say "phone pairing".
• (After the BEEP), say "pair a phone".
• Follow the audible prompts.
WARNING!
to begin.
34

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents