Setting The Rinse Aid Dosage - Miele dishwashers Operating Instructions Manual

Setting the rinse aid dosage

You can adjust the rinse aid dosage for
best results.
The rinse aid dosage can be set from
approx. 0-6 ml. It is set to a
recommended setting of approx. 3 ml
at the factory.
If spots appear on crockery and
glassware:
^ Increase the rinse aid dosage.
If clouding or smearing appears on
crockery and glassware:
^ Decrease the rinse aid dosage.
^ Switch the dishwasher off with the Off
button V.
^ Press the programme selector button
in and, whilst holding it in, switch
the dishwasher on using the On
button U .
Keep the programme selector button
pressed in for at least four seconds
until the lower right-hand programme
indicator comes on.
If this does not happen, start the
procedure from the beginning again.
^ Press the programme selector button
three times briefly.
The "Inlet/Drain" check light will flash
briefly three times at intervals.
Before using for the first time
The upper right-hand programme
indicator will flash briefly three times at
intervals.
This means that approx. 3 ml of rinse
aid will be used per programme
(factory default setting).
The number of times the upper
right-hand programme indicator flashes
tells you the water hardness level which
has been set (see chart).
Rinse aid
in ml
0
1
2
3
4
5
6
^ Press the programme selector button
for at least one second until the
"Inlet/Drain" check light comes on.
^ Press the programme selector button
briefly to select the number of flashes
which equates to the rinse aid
dosage you want.
Each press on the button moves you
up a level.
The programmed rinse aid dosage is
now stored in memory.
^ Switch the dishwasher off with the Off
button V.
Flashing frequency
-
Once
Twice
Three times
Four times
Five times
Six times
21