Floormat - Club Car 1998 DS Maintenance Service Manual

4
BODY AND TRIM
REAR BODY INSTALLATION
1. Install two screws in kick-plate. Tighten to 20 in.lb (2.3 N-m) (Figure 4-3, Page 4-6) .
2. Tighten two screws (1) and locknuts located under bagwell protector in bagwell floor to 20 in.lb (2.3 N-m)
(Figure 4-2, Page 4-6) .
3. Tighten two carriage bolts (1), nuts (2), and washers (3) attaching the rear legs of the seat back sup-
port assembly to the body to 11 ft. lb (14.9 N-m) (Figure 4-6, Page 4-7) .
4. Tighten four screws (1), flat washers (2), and spacers (3) attaching the front legs of the seat back sup-
port assembly to the body to 20 in.lb (2.3 N-m) (Figure 4-7, Page 4-7) .
NOTE
• INSTALL THE MOUNTING PADS (4) (FIGURE 4-6, PAGE 4-7) BETWEEN THE REAR BODY AND
THE SEAT BACK ASSEMBLY.
5. Adjust choke positioner. See Section 14–Fuel System, in the FE 290 Gasoline Vehicle Supplement.

FLOORMAT

FLOORMAT REMOVAL
1. Remove the brake and accelerator pedals. See Section 5–Accelerator and Brake Pedal Group.
2. Loosen two screws in the rear body kick-plate (Figure 4-3, Page 4-6) and pull the rear edge of the
floormat from between the rear body and the floor panel.
3. Remove the top edge of the floormat from the overlapping flange under the dash.
4. Lift the mat from the vehicle.
FLOORMAT INSTALLATION
1. Install the brake and accelerator pedals. See Section 5–Accelerator and Brake Pedal Group.
2. Reverse the removal procedure to install the floormat. Tighten screws to 20 in.lb (2.3 N-m).
Page 4-8 1998/1999 DS Golf Car Maintenance and Service Manual
Floormat