CITROEN DS3 Owner's Handbook Manual page 150

Remove the kit, taking care to avoid
staining your vehicle with traces of fluid.
Keep the kit to hand.
Drive immediately for approximately
three miles (five kilometres), at reduced
speed (between 15 and 35 mph [20 and
60 km/h]), to plug the puncture.
Stop to check the repair and the tyre
pressure using the kit.
Turn the selector A to the AIR position.
Connect the black pipe D to the valve of the
wheel.
Checking/Adjusting tyre pressures
You can use this kit to inflate other accessories such as a ball or bicycle tyres.
To do this, turn the selector to the "Inflation (AIR)" position, connect the black pipe with the
appropriate adaptor to the accessory to be inflated, then follow the rest of the procedure
below as far as removal of the kit.
You can also use this kit for routine checking and adjustment of the tyre pressures on your
vehicle. For this, carry out just the following 6 points.
Connect the compressor's electric plug to
the vehicle's 12 V socket.
Start the vehicle again and leave the
engine running.