Yamaha YZ250T1 Owner's Service Manual page 47

1 Clamp
2 Radiator hose
3 Solenoid valve lead
4 TPS (throttle position sensor)
lead
5 Air vent hose (left)
6 Crankcase breather hose
7 Overflow hose
8 Air vent hose (right)
CABLE ROUTING DIAGRAM
A Insert the tip of the fuel tank
breather hose into the hole in
the steering shaft cap.
B Pass the radiator breather hose,
ignition coil lead and C.D.I.
magneto lead between the
frame and the left of the radia-
tor.
C Clamp the C.D.I. magneto lead
and ignition coil lead to the
frame.
D Install the side core and ignition
coil together to the frame.
E Pass the radiator breather hose
from the outside of the engine
bracket to the inside of the
downtube. Pass the radiator
breather hose on the inside of
the C.D.I. magneto lead.
F Clamp the C.D.I. magneto lead,
radiator breather hose and
Y.P.V.S. breather hose.
2-15
SPEC
G Clamp to the frame the radiator
breather hose and C.D.I. mag-
neto lead.
H Pass the C.D.I. magneto lead
and radiator breather hose in
front of the radiator hose.
I Pass the throttle cable behind
the air vent hose.
J Pass the air vent hose, overflow
hose and crankcase breather
hose so that they do not contact
the rear shock absorber.
K Clamp the air vent hoses.