Sea-doo Speedster 5894 Shop Manual page 54

Section 04 ENGINE
Sub-Section 01 (REMOVAL AND INSTALLATION)
1
F01L2TA
TYPICAL - 717 ENGINE SHOWN
1. Shaft end
2. PTO flywheel
If the alignment is incorrect loosen engine sup-
port screws to enable to align PTO flywheel with
shaft end.
'
NOTE : Use shim(s) (P / N 270 000 024) or (P
/ N 270 000 025) as necessary between en-
gine support and rubber mounts to correct align-
ment.
1
F01D32A
TYPICAL - 717 ENGINE SUPPORT SHOWN
1. Shim
-
CAUTION : Whenever shims are used to
correct alignment, never install more then
6 mm (0.240 in) shim thickness. If alignment
cannot be obtained verify for engine support
bending.
04-01-10
6, Screw and Loctite 242 (Blue)
Apply Loctite 242 (blue) on screw threads.
2
Retorque engine support screws to 25 N•m (18
lbf•ft) when procedure is completed.
'
NOTE : Whenever alignment tool is not uti-
lized, apply BOMBARDIER LUBE lubricant
on its shaft and inside the housing to eliminate
possible corrosion.
Electrical Connections
Properly resecure electrical wires / cables.
;
WARNING : To prevent any possible
spark that may occur at the battery termi-
nals while connecting the cables, unscrew and
disconnect the connector at the electrical box
PRIOR TO CONNECTING THE BATTERY CA-
BLES.
F04H28A
1. Electrical box connector
After connecting the battery, reinstall the electri-
cal box connector.
;
WARNING : Always connect RED positive
ca-ble first then BLACK negative cable
last.
Final Inspection
Check throttle cable condition and lubricate cable
with BOMBARDIER LUBE lubricant. After its in-
stallation, properly adjust and bleed oil injection
pump as specified in LUBRICATION SYSTEM, 07-
02.
Pressure test fuel system, refer to FUEL SYSTEM
06-03 and look for Fuel System Pressurization.
Verify all connections and hoses condition.
Run engine(s) and ensure there is no leakage.
1