3. Pull the surface unit straight away
from the receptacle.
Replacing
4. Lift out the reflector
bowl and trim
ring.
See Cleaning
Chart on page
22
for cleaning
instructions.
I
I
2. Line up opening
in the reflector
bowl and notch in the trim ring
with the surface unit receptacle.
3. Hold the surface unit as level as
possible
with the terminal
just
started into the receptacle.
4. Push the surface unit terminal
into
the receptacle.
When the terminal
is pushed
into the receptacle
as
far as it will go, the surface unit will
fit into the trim ring.