Advertisement
Programming New Or Replacement Transmitters (BANK 1)
Transmitter Model Name 145SP Is Also Found On Back Of
Transmitter Case. Use Battery CR2032
1) Turn the ignition key to the on position.
2) Press and release the valet/programming switch 3 times (Siren Chirps).
3) Press the Lock Button of each transmitter you want programmed until
you hear a chirp from the horn or siren.
4) Turn the ignition switch off.
The above action programs the Lock, Unlock, Start/Trunk, and Option 1
buttons which are typical for most systems.
For additional channel programming beyond the option 1 button, you can
use any unused button or combination of buttons not in use.
In other words, to access option channel 5, 6, 7, you would do the
following:
From step 3 above:
a) Press and release the valet/programming button 4 additional times to
get to channel 5, then Press any unused transmitter button or button
combination to program.
b) From a, press and release the valet/programming button 1 time to
get to channel 6, then press any unused transmitter button or button
combination to program.
c) From b, press and release the valet/programming button 1 time to
get to channel 7, then press any unused transmitter button or button
combination to program.
NOTE: Not all systems have channels above 3, check with your instal-
lation center for options your system may or may not have.
NOTE: Certain systems have the ability to utilize channels 6 & 7 for
driver priority programming. For driver priority, the vehicle must
be equipped with this feature, and the optional feature must be
set up and installed by your installation center. Once this feature
is added when the unlock button of transmitter 1 is used, it will
set driver 1 priority, and when the unlock button of transmitter
2 is used it will set driver 2 priority. In this situation, the unlock
button can be programmed into two receiver channels, unlock,
channel 2 and driver priority 6 or 7. In no other circumstance
Page 11
128-9301
11 of 12
Advertisement
