Figure 48. X-Axis Belt Replacement; X-Axis Belt Replacement - Ioline FJ Printer Service Manual

84 Ioline FJ Printer & StudioJet Service Manual
Leave loose
Photo 1
Photo 4

X-axis belt replacement

Tools Required

Phillips head screwdriver
1. Follow the right side cover removal procedure.
2. Hold the X-motor and unscrew two of the Phillips screws
holding the motor (Figure 48, photos 1, 2 & 3). Leave the screw
shown in Figure 49, photo 1 loose. Do not remove it.
3. Rotate the small pulley toward the front of the machine (Figure
48, photo 4).
4. Remove X-belt from both pulleys.
5. Install the new belt around both pulleys.
6. Rotate the small pulley toward the back of the machine (Figure
48, photo 3).
7. Install the two screws that hold motor (leave all three screws
loose for now). (Figure 48, photos 2 & 1).
8. Push the pulley toward the back of machine and hold (for tension).
Photo 2
Photo 5

Figure 48. X-axis belt replacement.


11/32" wrench
Photo 3