Figure 46. Power Supply Replacement - Ioline FJ Printer Service Manual

5. Plug the big connector into the new power supply (Figure 46,
photos 5 & 4).
6. Install the new power supply into the plotter body. Make sure you
insert the bottom tab into the gap built into the body of the machine
(Figure 46, photo 3). Check the other power supply for an example.
7. Plug in the small connector (Figure 46, photos 2 & 1).
8. Route the wires, making certain they lay out of the way of the
bottom cover screws (Figure 46, photo 6).
9. Install the bottom cover and the rotate machine back to normal
operating position. Make sure to re-install screws that hold the
machine to the stand legs.
10. Test the plotter.
11. If problems arise, contact Ioline Tech Support.
Connector
Photo 1
Connector
Photo 4
Photo 5

Figure 46. Power supply replacement.

Photo 2
Photo 6
Chapter 4: Repair Procedures
Photo 3
81