Transfer Case; Automatic Transmission - Jeep 2010 Grand Cherokee Owner's Manual

Selection of Lubricant
Use only the manufacturer's recommended fluid. Refer
to "Fluids, Lubricants, and Genuine Parts" in this section
for the correct fluid type.

Transfer Case

Fluid Level Check
Inspect the transfer case for fluid leaks. If a fluid leak is
found, the transfer case fluid level can be checked by
removing the filler plug located on the back side of the
transfer case. The fluid level should be at the bottom edge
of the filler plug hole when the vehicle is in a level position.
Adding Fluid
Add fluid at the filler hole, until it runs out of the hole,
when the vehicle is in a level position.
Drain
First remove fill plug, then remove drain plug. Recom-
mended tightening torque for drain and fill plugs is 15 to
25 ft lbs (20 to 34 N·m).
MAINTAINING YOUR VEHICLE 381
CAUTION!
When installing plugs, do not overtighten. You could
damage them and cause them to leak.
Selection of Lubricant
Use only the manufacturer's recommended fluid. Refer
to "Fluids, Lubricants, and Genuine Parts" in this section
for the correct fluid type.

Automatic Transmission

Selection of Lubricant
It is important that the proper lubricant is used in the
transmission to assure optimum transmission perfor-
mance. Use only the manufacturer's recommended trans-
mission fluid. Refer to "Fluids, Lubricants, and Genuine
Parts" in this section for the correct fluid type. It is
important that the transmission fluid be maintained at
the prescribed level using the recommended fluid.
7