Fixing The Indoor Unit In Place; Fixing The Outdoor Unit In Place - Samsung AQV09F Series Installation Manual

C I
OMPLETING THE NSTALLATION

Fixing the Indoor Unit in Place

Installation plate

Fixing the Outdoor Unit in Place

'X' mm
Rubber leg
Model
AQ09/12FC
538
AQ09/12NSA
AQ09/12VBC
543
AQ09/12NSB
660
18/24
Designed to cut off
residual vibration from
outdoor unit to rack. (not
supplied with product)
Soft rubber designed to cut
off vibration from rack to wall.
(not supplied with product)
18
E-
08'FORTE_VIVACE_Inv_IM_28492A£¨4£©_E.indd 18
After checking for gas leaks in the system, insulate the pipe, hose and cables.
Then place the indoor unit on the installation plate.
1
To avoid condensation problems, place heat-resistant polyethylene foam
separately around each refrigerant pipe in the lower part of the indoor unit.
2
Wrap the refrigerant pipe and the drain hose in the rear of the indoor unit with
the absorbent pad.
 Wind the pipe and hose three times to the end of the indoor unit with the
3
Wind the pipe, assembly cable and drain hose with insulation tape.
4 Place the bundle (the pipe, assembly cable and drain hose) in the lower part of
the indoor unit carefully so it doesn't project from the rear of the indoor unit.
5
Hook the indoor unit to the installation plate and move the unit to the right
and left until it is securely in place.
6
Wrap the rest of the pipe with vinyl tape.
7 Attach the pipe to the wall using clamps (optional).
Install the outdoor unit to a stable base to avoid the generation of noise and
vibration, especially when installing the unit close to a neighbor.
If you install the outdoor unit in a place exposed to strong winds or at a height,
fix it to an appropriate support (wall or ground).
1
Place the outdoor unit as indicated on the top of the unit to let the
discharged air out properly.
X Y 2
Fix the outdoor unit to an appropriate support using anchor bolts.
290
3 If the outdoor unit is exposed to strong winds, install shield plates around the
outdoor unit so that the fan can operate correctly.
319
340
 Secure the rubber leg to prevent the generation of noise and vibration.
OUTDOOR UNIT INSTALLED ON THE WALL BY RACK
- Ensure the wall will be able to suspend the weight of rack and outdoor unit;
- Install the rack close to the column as much as possible;
- Install proper grommet in order to reduce noise and residual vibration trans-
ferred by outdoor unit towards wall.
absorbent pad. (20mm interval)
2007-12-6 9:32:59