Operation; Cancelling And Resetting The Programme; Start Delay Function - Hoover Vision HD Instruction Book

40005228.qxd 20/02/2008

Operation

1. Open the door and load the drum with laundry. Ensure that garments do
not hinder closure of the door.
2. Gently close the door pushing it slowly until you hear the door 'click' shut.
3. Press the 'Marche Arrêt' button to switch on the dryer. The indicator will
light up and the programme number will be indicated.
4. Turn the Programme Selector dial to select the required drying programme
(see Programme Guide).
5. If drying synthetics, acrylics or delicate items, press the 'Séchage Délicat'
button to reduce the heat level.
The light above the push button will light up when the machine is in low
heat setting. To deselect this status the machine must be reset.
6. Press the 'Départ Pause' button. The dryer will start automatically and the
'Temps Restant' indicator will be continuously lit. The time to the end of
the programme will be shown on the display.
7. The display will show the drying progress in terms of time remaining, the
'Temps Restant' indicator will remain lit.
8. If the door is opened during the programme to check the laundry, it is
necessary to press 'Départ Pause' to recommence drying after the door has
been closed.
9. When the 15' indicator is lit the machine will enter the cool down phase,
the clothes will be tumbled in cool air allowing the load to cool down.
10. When the programme is complete the Display will show 0'min. and the
buzzer will sound for 10 seconds.
11. Following the completion of the cycle the drum will rotate intermittently to
minimise creasing, the buzzer will also sound. This will continue until the
machine is reset or switched OFF.

Cancelling and resetting the programme

To cancel a programme switch the machine off and on again. The machine will
indicate that it has been reset by the display flashing.
Delay Start Function
The Delay Start function (Départ Différé) allows the user to delay the start of the
drying cycle by up to 23 hours.
When the function is first selected the display will show a delay of 1 hour,
subsequent presses of the button will increase the delay by 1 hour to a maximum
of 23 hours.
16
12:31 Page 16