Operation; Cancelling And Resetting The Programme - Hoover Vision HD VHC381 Instruction Book

40005501.qxd 12/03/2008

Operation

WARNING!
The drum, door and
load may be very hot.
16
11:08 Page 16
1.
2.
3.
4.
5.
6.
7.
8.
9.
10. When the programme is complete the STOP indicator will
11. Following the completion of the cycle the drum will
Cancelling and resetting the
programme
To cancel a programme switch the machine off and on again.
The machine will indicate that it has been reset by the START
indicator flashing.
Buzzer Operation
The buzzer will operate when the selector is rotated and when
function buttons are pressed.
To cancel the operation of the buzzer, follow this sequence.
Press and hold on the Acrylic/Synthetic and Start/Pause buttons
and then turn the machine ON using the ON/OFF switch.
To switch the buzzer back on repeat the above sequence.
Open the door and load the drum with laundry. Ensure
that garments do not hinder closure of the door.
Gently close the door pushing it slowly until you hear the
door 'click' shut.
Press the On/Off button to switch on the dryer. The
On/Off indicator will light up and the START indicator will
flash.
Turn the Programme Selector dial to select the required
drying program (see Programme Guide).
If drying synthetics, acrylics or delicate items, press the
Acrylic/Synthetic button to reduce the heat level.
The light above the push button will light up when the
machine is in low heat setting. To deselect this status the
machine must be reset.
Press the Start/Pause button. The dryer will start
automatically and the START indicator will be
continuously lit.
The display will show the drying progress in terms of time
remaining.
If the door is opened during the programme to check the
laundry, it is necessary to press Start/Pause to recommence
drying after the door has been closed.
When the 15' indicator is lit the machine will enter the
cool down phase, the clothes will be tumbled in cool air
allowing the load to cool down.
light.
rotate intermittently to minimise creasing. This will
continue until the machine is reset or switched OFF.