TrekStor USB-Storage 2.0 User Manual page 10

1 Getting Started
2. Now you can carefully remove the rear panel which is connected to a card. The card will come off together with the panel.
3. (3.5 inch version): connect the hard disk both to the IDE port and to the power supply. Make sure all plugs are connected
properly. Screw the hard disk to the card from underneath using the provided screws.
4. (2.5 inch version): plug the hard disk directly into the 44-pin IDE port on the card.
5. Close the casing and tighten it using the provided screws.
4
TrekStor