Samsung SCX-6555N Service Manual page 197

Message
Paper Jam at the top of
duplex path
Paper Jam in exit area
Paper Jam in MP tray
Paper Jam in tray1
Paper Jam in tray2
or
Paper Jam in tray2(HCF)
Paper Jam in tray2
or
Paper Jam in tray2(HCF)
Paper Jam in tray2
or
Paper Jam in tray2(HCF).
Service Manual
CÓPIA NÃO CONTROLADA
Alignment & Troubleshooting
Description
Paper has jammed during duplex
printing.
Paper has jammed in the fuser area. 1. Open the Side door and remove the
Paper misfed from multi-purpose
tray.
Paper has jammed in the feeding
area of the tray.
Paper has jammed in the feeding
area of the tray.
Paper has jammed in the feeding
area of the tray.
Paper has jammed in the feeding
area of the tray.
CÓPIA NÃO CONTROLADA
1. Open the side door and remove the
jammed paper.
2. If there is not jammed paper but the error
message is occurred, check the duplex
sensor. (Component Test)
jammed paper.
2. If there is not jammed paper but the error
message is occurred, check the Exit
sensor. (Component Test ->Sensor Read
-> Ex value)
1. If pick up roller does not rotate , check the
pick up clutch.
2. If Pickup roller is rotating but the paper is
not feeding, replace the pick up rubber.
3. Check the feed sensor. If it is defective,
replace it.
1. If pick up roller does not rotate , check the
pick up clutch.
2. If Pickup roller is rotating but the paper is
not feeding, replace the pick up rubber.
3. Check the feed sensor. If it is defective,
replace it.
1. Open the side door and Tray2 door and
remove the jammed paper.
2. If there is not jammed paper but the error
message is occured, check the Feed
sensor or Hardware.
3. If the paper is feeding by rotating the
pick up roller, check the clutch and clutch
signal.
1. Open the side door and Tray2 door and
remove the jammed paper.
2. If there is not jammed paper but the error
message is occured, check the Feed
sensor or Hardware.
3. If the paper is feeding by rotating the
pick up roller, check the clutch and clutch
signal.
1. If pick up roller does not rotate , check the
pick up clutch.
2. If Pickup roller is rotating but the paper is
not feeding, replace the pick up rubber.
3. Check the feed sensor. If it is defective,
replace it.
4-97
Suggested solutions
Samsung Electronics