IBM Motherboard User Manual page 36

PCI Master
This item enable or disable
command.
Resume by PCI PME
This item specifies whether the system will be awakened from power saving modes
when activity or input signal of the specified hardware peripheral or component is
detected.
Resume by RING
An input signal on the serial Ring indicator (RI) line (in other words, and incoming
call on the modem) awakens the system from a soft off state.
RTC Alarm Resume
The system can be turned off with a software command. If you enable this item,the
system can automatically resume at a fixed time based on the system RTC (realtime
clock). Use the items below this one to set the date and time of thewake-up alarm.
You must use an ATX power supply in order to use this feature.
Date (of Month)
This item specifies the date for
Resume Time
This item specifies the date for
IRQs Activity Monitoring (Press Enter)
Scroll to this item and press <Enter> to view the following screen:
Primary INTR
IRQ3 (COM 2)
IRQ4 (COM 1)
IRQ5 (LPT 2)
IRQ6 (Floppy Disk)
IRQ7 (LPT 1)
IRQ8 (RTC Alarm)
IRQ9 (IRQ2 Redir)
IRQ10 (Reserved)
IRQ11 (Reserved)
IRQ12 (PS/2 Mouse)
IRQ13 (Coprocessor)
IRQ14 (Hard Disk)
IRQ15 (Reserved)
: Move Enter: Select +/-/: Value F10: Save Esc: Exit
F1: General Help F5: Previous Values F6: Fial-Safe Defaults F7: Optimized Defaults
Chapter 3: BIOS Setup Utility
hat the system will be waken up by PCI master
t
RTC Alarm Resume
" ".
" RTC Alarm Resume " .
Phonex-AwardBIOS CMOS Setup Utility
IRQs Activity Monitoring
[ON]
[Disabled]
[Enabled]
Menu Level
[Enabled]
[Enabled]
[Enabled]
[Disabled]
[Disabled]
[Disabled]
[Disabled]
[Enabled]
[Enabled]
[Enabled]
[Disabled]
33
Help Item